Home » Archive by category "Machining"

SARS-CoV2 (Covid-19) Statement.

Whilst we are currently under no Government restrictions, and we are still operating, we are severely restricted due to childcare issues.  

This obviously has affected our output and ability to hit required deliveries.

For the protection of our staff and families we are operating with reduced staff and have restricted access to our premises to essential staff,  and all visits by appointment  only.
For any deliveries or collections, we request that you advise your drivers to strictly obey the current guidelines in place and to remain at least 2m away from our staff.
Anyone showing any symptoms will be refused access!
Thank you for your co-operation.

Recently manufactured pair of Hydraulic Cylinders

These cylinders have dual ports in each end to allow them to replace handed cylinders on rigid pipes.  This allows the end user to only require one as a spare for two working cylinders.  Our customer supplied drawings specified by the end user to be a direct copy to existing cylinders but with the added benefit of dual ports at each end.

Ready for assembly and test
Cylinder Heads
Cylinder Heads ready to install.

Highspeed machining courtesy of Kyocera

Cutting an 18mm x 97mm x 75mm deep slot in En24T with a Kyocera MFH17-S16-2T RAPTOR, a  twin insert Highfeed 17mm indexable endmill…

0.7mm feed/tooth, 0.5mm depth of cut, 160m/min.

Zig-zag slot cut then wall finish to size @ z-0.4mm per pass.    It will go quicker with less overhang.

Machine: Dugard Eagle 1000 VMC